Winix AIR PURIFIER
C710
replacement filter
YOUR FILTER MATCH
Filter Z
1712-0121-00
Your C710 needs one canister per change.
Third-party alternative on Amazon
PUREBURG two-pack.
Two replacement canisters = two changes for one purifier. This alternative is not made by Winix; the listing names C710, but we have not independently tested its fit or filtration performance.
As an Amazon Associate I earn from qualifying purchases.
View PUREBURG two-pack on Amazon ↗Amazon package: Two combined replacement canister filters. Listing checked 2026-09-20. Confirm the current variant, seller and pack count; availability varies.
Check the Winix C710 manual (PDF) for the original part match. Source checked 2026-09-25.
Prefer genuine Winix? Check Filter Z at Winix ↗. Product page checked 2026-10-10; confirm current stock and package quantity.
- Manufacturer
- Winix
- Purifier model
- C710
- Filters needed in this purifier
- 1
- Replacement guidance
- Replace this filter set approximately every 12 months; conditions can shorten its service life.
- Filter configuration
- One all-in-one canister installed per purifier. Check the replacement seller’s pack count separately.
Replace the filters in your C710
- Switch off, unplug, and let the purifier cool. Turn it upside down and rotate the bottom handle counterclockwise to remove the cover.
- Turn the filter’s upper cap counterclockwise to separate it. Replace the used canister and remove the new filter’s protective wrapping. Keep the pre-filter layer attached.
- Align the assembly with the square opening shown in the manual. Secure the upper cap clockwise, then turn the bottom handle clockwise to close the cover. Return the purifier upright before reconnecting power.
Reset the filter light
The C710 manual is inconsistent: control-panel item 01 specifies a 10-second hold on Filter Life / Filter Reset; the Replacing Filters section specifies at least 5 seconds with power on, until a beep. Use the instructions supplied with your unit or confirm the procedure with Winix if the reminder does not clear. Reset only after replacing the filter.
With the purifier unplugged, use a vacuum or soft brush on the outer pre-filter only, about every 14 days. Do not wash the canister or attempt to clean the HEPA media. Cleaning the pre-filter does not replace changing the spent canister.
Read the Winix manual (PDF) — page(s) 1 (Initial Operation, Maintenance, Cleaning Care and filter controls). Checked 2026-09-25. C710 manual linked from Winix’s current product page. Follow the full manual if your controls differ.
Compatibility source
This page reports model-to-filter compatibility. It does not independently test filtration performance or certify third-party alternatives.